Program card for Speedstar Brushless

Immediately after the programmer is plugged to the ESC, it saves the Speedstar BL current settings to its internal memory.
Modify the ESC parameters to your personal preferences and download them to the Speedstar BL for instant setup.
Depending on the Speedstar BL model, there is a multitude of parameters to choose from.
Display maximum and current temperature or show the maximum speed calculated in km/h!
Fits all models of the Speedstar BL series.

Adjustable & Analyze Parameter:

Battery LiPo / LiFe / NiMH (NiCd)
Cutoff voltage Auto / 3.0V - 14V (0,1V) Auto
Power curve Soft / Linear / Hart Linear
Advance Timing 0-25 (Sensorless) / 0-10 (Sensor)
Acceleration Lowest / Low / Normal / High / Highest
Start power Lowest / Low / Normal / High / Highest
Start Current Limit Off, 1% - 100%
Current Limit Off, 1% - 100%
Reverse Function One way / Two way
Reverse Delay 0,2s/0,5s/0,8s/1,3s/1,8s/2,5s
Neutral Width Narrow / Normal / Wide
Motor Direction Normal / Reverse
Speed Mixing Brake 0% - 100% (10% Steps)
A.B.S. Brake Off / Weakest / Weak / Normal / Strong / Strongest
Auto Brake Amount 0% - 100% (1% Steps)
Min. Brake Amount 0% - 100% (1% Steps)
Max. Brake Amount 0% - 100% (1% Steps)
Current Voltage XX,X V (Display)
CurrentTemperature 0 - 135 (Display)
Max. Temperature 0 - 135 (Display)
Max. Current 0A - 999A (Display)
Motor Pole 2 - 20 Pole
Gear Ratio 2,0:1 - 15,0:1
Tire Diameter 40mm - 200mm
Max. Speed XXX,X km/h (Display)
Average Speed XXX,X km/h (Display)
Error History (T) Temperatur, (S) Sensor, (V) Voltage, (R) Signal (Display)
Download Parameters are downloaded to the speedo
Restore Memory EEPROMs Data saved into the RAM of the Programmer.
Backup Memory RAMs Data saved into the EEPROM
Factory Setting Restes all data into default